How To Use Tag-Connect Cables With The Lattice HW-USBN-2B Debugger
Lattice HW-USBN-2B Cable Selection and Installation
6-pin TC2030 for FPGA/CPLD programming using JTAG
The JTAG solution combines our TC-LATTICE adapter with a TC2030-IDC (legged) or TC2030-IDC-NL (no-legs) 6-pin programming cable.
By default, the TC-LATTICE adapter comes fitted with a 500 Ohm resistor connected between VCC and GND. This resolves the issue of the Lattice HW-USBN-2B unexpectedly raising VCC on low-power targets and eliminates the need for the resistor to be fitted to each of your target PCB’s
* 500 Ohm Resistor fitted on back of Adapter PCB between VCC and GND