How To Use Tag-Connect Cables With MikroE Debuggers
MikroE's CODEGRIP and mikroProg debuggers use MikroE connectors whose pinout differs from the standard Cortex 10-pin layout that most Tag-Connect cables expect. The direct route to Tag-Connect is MikroE's CODEGRIP ADAPT V6, a 6-pin SWD needle adapter.
In short: plug the CODEGRIP ADAPT V6 into the CODEGRIP and connect a 6-pin needle cable such as the TC2030-IDC (legged) or TC2030-IDC-NL (no legs) for SWD programming. Check the ADAPT V6 schematic pinout first. For JTAG on STM32 or ICSP on PIC, go through the matching MikroE adapter first, as shown below.
Recommended Routes
| Debugger and target | Route |
|---|---|
| CODEGRIP, SWD | CODEGRIP ADAPT V6 with TC2030-IDC, or TC2030-IDC-NL with a TC2030-CLIP |
| mikroProg for STM32, JTAG | MikroE 20-pin JTAG adapter, then TC2050-ARM2010 with TC2050-IDC |
| mikroProg for STM32, SWD | MikroE 20-pin JTAG adapter, then ARM20-CTX with TC2030-IDC |
| mikroProg for PIC, dsPIC and PIC32 | MikroE RJ12 (ICD2/ICD3) adapter, then TC2030-MCP |
The adapter routes rely on matching standard connectors: MikroE and Tag-Connect don't publish them as tested pairings. Check the adapter's output pinout, and the gender of the RJ12, before laying out a board.
Things to Watch
- Never plug a TC2050-IDC straight into a CODEGRIP or mikroProg unless your board's footprint follows MikroE's pinout, which differs from the standard Cortex layout.
- MikroE lists the CODEGRIP ADAPT V6 for SWD only.
- MikroE pitches the ADAPT V6 and needle cable at production programming, with a no-legs cable held by hand, or retained with a TC2030-CLIP for debugging.
Frequently Asked Questions
Can I connect a Tag-Connect cable directly to a MikroE CODEGRIP?
Use the CODEGRIP ADAPT V6 between them. It converts the CODEGRIP to a 6-pin 0.1 in SWD needle-cable connector; a TC2030-IDC is a suitable cable once you've checked the V6 pinout.
Does the CODEGRIP ADAPT V6 support JTAG?
MikroE lists it for SWD only and doesn't mention JTAG.
Related Guides
Sources
- MikroE CODEGRIP ADAPT V6
- Tag-Connect: IDC cable range
- MikroE mikroProg to ST-Link v2 Adapter (MIKROE-1303)
- MikroE mikroProg to ICD2/ICD3 Adapter (MIKROE-791)
- Tag-Connect TC2030-MCP
Last reviewed 22 November 2026 by The Debug Store, supplier of MikroE and Tag-Connect tools.