Aaronia AG
Aaronia IsoLOG 3D Mobile PRO
Aaronia IsoLOG 3D Mobile PRO
Couldn't load pickup availability
Overview
The new IsoLOG 3D Mobile, Aaronia's latest development, is an ultra light and small isotropic antenna which is compatible to any spectrum analyzer. It just works on the fly and is a perfect plug and play solution for 3D measurements in limited time frames. The antenna requires no software installation, no power connection and no hardware changes. It is connectable via the N (male) connector to any analyzer or oscilloscope.|
|
ISOLOG 3D® MOBILE 9030 PRO | ISOLOG 3D® MOBILE 9060 PRO | ISOLOG 3D® MOBILE 9080 PRO |
|---|---|---|---|
| Design | 3D (isotropic) | 3D (isotropic) | 3D (isotropic) |
| Frequency Range | 9kHz-3GHz | 9kHz-6GHz | 9kHz-6GHz |
| Internal Preamps | Two (+15dB each (@2GHz)) | Two (+15dB each (@2GHz)) | Two (+15dB each (@2GHz)) |
| Nominal impedance | 50 Ohm | 50 Ohm | 50 Ohm |
| Gain (typ.) | Up to 10dBi | Up to 10dBi | Up to 10dBi |
| RF-Connector | N Female/N Male | N Female/N Male | N Female/N Male |
| Dimensions (L/W/D) | 340 x 75 x 75 mm | 340 x 75 x 75 mm | 340 x 75 x 75 mm |
| Weight | 350g | 350g | 350g |
| Warranty | 2 years | 2 years | 2 years |
Each IsoLOG 3D Mobile includes an internal, rechargeable battery, offering a run-time of 6 hours, and two switchable low noise bypass preamplifier (+15dB each (@2GHz)). The integrated amp allows measurements of very low-powered signals. Thus, used in bypass mode, the antenna is still usable for high field-strengths. The control of the antenna is done via USB or via manual antenna selection mode, requiring no USB connection.
Made in Germany
All Aaronia antennas are developed, individually produced and calibrated in Germany at the Aaronia factory. This guarantees highest standards so that Aaronia can offer every customer a full 2 years warranty for all EMC antennas.
Frequently Asked Questions
Have a Question?
Be the first to ask a question about this.