Hantek 2D82 Kfz-Diagnosekit II
Hantek 2D82 Kfz-Diagnosekit II
Die brandneuen Kfz-Diagnosekits der Serie Hantek-2000 sind ein unverzichtbares elektronisches Diagnosetool für den Kfz-Techniker.
Das Kit basiert auf dem 4-in-1-Multifunktionstester Hantek-2D82 mit einem klaren LCD-Farbdisplay, einschließlich:
- Multifunktionstester für Autosysteme
- Zweikanaliges Digitaloszilloskop
- Digitalmultimeter
- Signalgenerator
Der Hantek-2D82 zeichnet sich durch einen geringen Stromverbrauch aus, sodass er den ganzen Tag ohne Aufladen verwendet werden kann, und ein einfaches Tastaturdesign sorgt für eine leichte Bedienung.
Jedes Kit enthält eine einzigartige Sammlung von Leitungen und externen Sensoren, sodass Sie auswählen können, was Ihren Anforderungen am besten entspricht.
Specifications
Model | Hantek-2D82-Auto | |||
Vehicle Testing | ||||
Vehicle Diagnosis | Vehicle Diagnostic Function | Ignition | Primary Ignition (Voltage) | |
Primary Ignition(current) | ||||
Primary Ignition(Voltage& Current) | ||||
Primary Ignition (Crankshaft Senser) | ||||
Primary Ignition&SecondaryIgnition | ||||
Secondary | Secondary Ignition Distributor Type (Plug Lead) | |||
Secondary Ignition Distributor Type (King Lead) | ||||
Secondary DIS (Positive-fired) | ||||
Secondary DIS or CPC (Negative-fired)) | ||||
Secondary Coil Output Diagnosis | ||||
Secondary Ignition&Primary Ignition | ||||
Sensors | Air Flow Meter | Air Flow Meter (Hot Wire) | ||
Air Flow Meter (Air Vane) | ||||
Air FlowSensor (BOSCH Diesel) | ||||
Air Intake PressureSensor (BOSCH Diesel) | ||||
Camshaft | Camshaft (Inductive) | |||
Camshaft (AC Excited) | ||||
Camshaft (Hall Effect) | ||||
Camshaft (BOSCH Common Rail Diesel) | ||||
Crankshaft | Crankshaft Inductive Running | |||
Crankshaft Inductive Cranking | ||||
Crankshaft Hall Effect | ||||
Crankshaft Sensor &Primary Ignition | ||||
Distributor | Distributor Pick-up (Hall Effect) | |||
Distributor Inductive Pick-up Cranking | ||||
Distributor Inductive Pick-up Running | ||||
Lambda Sensors | Lambda Sensor Titania | |||
Lambda Sensor Zirconia | ||||
Lambda Sensor Zirconia Pre & Post cat | ||||
Throttle Position | Throttle Position Potentiometer | |||
Throttle Position Switch | ||||
Throttle Pedal Switch (Bosch Diesel) | ||||
ABS Digital Speed Sensor | ||||
ABS Analog Speed Sensor | ||||
Coolant Temperature (5V) | ||||
Coolant Temperature (GM/Vauxhall Simtec | ||||
Crash Sensor | ||||
MAP Analog | ||||
MAP Digital | ||||
Hall Effect Road Speed Sensor | ||||
Accelerator Pedal (Bosch Diesel) | ||||
Bus Diagnosis | CAN Bus | CAN Bus Data View | ||
CAN Bus Signal Integrity | ||||
CAN Bus LH Long Capture | ||||
LIN Bus | LIN Bus | |||
Engine | Petrol | Single-point Injector (Voltage) | ||
Single-point Injector (Current) | ||||
Multi-point Injector (Voltage) | ||||
Multi-point Injector (Current) | ||||
Injector Voltage & Current | ||||
Injector Current & Primary Ignition | ||||
Diesel | Common Rail Diesel (Current) | |||
Injector Bosch CDi 3 (Current) | ||||
Injector Bosch Diesel (Idling) | ||||
Injector Bosch Diesel (Accelerating) | ||||
Diesel Glow Plugs | ||||
Electronic Fuel Pump | ||||
Carbon Canister Solenoid Valve | ||||
ERG Recirculation Solenoid Valve | ||||
Stepper Motor Example 1 | ||||
Stepper Motor Example 2 | ||||
Idle Speed Control Valve (Rotary) | ||||
Idle Speed Control Valve (Electromagmetic) | ||||
Throttle Servomotor (Idling) | ||||
Throttle Servomotor (Accelerating) | ||||
Bosch CDi3 Quantity Control Valve | ||||
Bosch CDi3 Pressure Regulator Valve | ||||
Variable-Speed Cooling Fan On | ||||
Variable-Speed Cooling Fan Off | ||||
Variable Camshaft Valve Timing | ||||
Startup & Charge | Charging Circuits | Charging Circuits Current/Voltage | ||
Charging Circuits Current/Voltage Starting 24V | ||||
Charging Circuits Current/Voltage Idling 24V | ||||
Charging Circuits Alternator AC Ripple/Diode Diagnosis | ||||
Relative Compression Petrol | ||||
Relative Compression Diesel | ||||
Starting Voltage Drop | ||||
Oscilloscope | ||||
Bandwidth | 80MHz | |||
Channel | 2CH+DMM+AWG | |||
Horizontal | ||||
Sample Rate Range | 250MSa/s(Single-channel), 125MSa/s(Dual-channel) | |||
Waveform Interpolation | (sin x)/x | |||
Record Length | 3K samples per dual-channel | |||
SEC/DIV Range | 5ns/div~500s/div 1, 2, 5 sequence | |||
Vertical | ||||
A/D Converter | 8-bit resolution,each channel sampled simultaneously | |||
VOLTS/DIV Range | 10mV/div~10V/divat input BNC | |||
Bandwidth Limit, typical | 20MHz | |||
Low Frequency Response (-3db) | ≤10Hz at BNC | |||
Rise Time at BNC, typical | ≤5ns | |||
DC Gain Accuracy | ±3% for Normal or Average acquisition mode, 10V/div to 10mV/div | |||
Note: Bandwidth reduced to 6MHz when using a 1X probe. | ||||
Acquisition | ||||
Acquisition Modes | Normal | |||
Trigger | ||||
Type | Edge | |||
Mode | Auto, Normal, single | |||
Level | ±4 divisions from center of screen | |||
Trigger Level Accuracy | 0.2div × volts/div within ±4 divisions from center of screen | |||
Slope | Rising, Falling, Rising & Falling | |||
Source | CH1/CH2 | |||
Input | ||||
Coupling | DC, AC or GND | |||
Input Impedance, | 25pF±3 pF, 1MΩ±2% | |||
DC coupled | ||||
Probe Attenuation | 1X, 10X | |||
Supported Probe Attenuation Factors | 1X, 10X, 100X, 1000X | |||
Maximum Input Voltage | 150VRMS | |||
Measurement | ||||
Cursor | Voltage difference between cursors: △V | |||
Time difference between cursors: △T | ||||
Automatic Measurements | Frequency, Amplitude | |||
Arbitrary Waveform Generator | ||||
Waveform Frequency | Sine: 1Hz~25MHz | |||
Square: 1Hz~10MHz | ||||
Ramp: 1Hz~1MHz | ||||
EXP: 1Hz~5MHz | ||||
Sampling | 250MSa/s | |||
Amplitude | 2.5Vpp(50Ω) | |||
5Vpp(High impedance) | ||||
Frequency Resolution | 0.001 | |||
Channel | 1CH waveform output | |||
Waveform Depth | 512Sa | |||
Vertical Resolution | 12 bit | |||
Frequency Stability | <30ppm | |||
Output Impedance | 50 Ω | |||
Multimeter | ||||
Maximum Resolution | 4000 Counts | |||
DMM Testing Modes | Voltage,Current,Resistance,Capacitance,Diode &On-Off | |||
Maximum Input Voltage | AC:600V, DC: 800V | |||
Maximum Input Current | AC: 10A, DC:10A | |||
Input Impedance | 10MΩ | |||
Measurement Term | Range | Accuracy | Resolution | |
DC Voltage | 400.00mV | ± (0.8% + 5) | 100uV | |
4.000V | 1mV | |||
40.00V | 10mV | |||
400.0V | 100mV | |||
600.0V | ± (1% + 2) | 1V | ||
Overload protection: 400mV: 250V, other: 600Vrms. | ||||
AC Voltage | 4.000V | ± (1.2% + 5) | 1mV | |
40.00V | 10mV | |||
400.0V | 100mV | |||
600.0V | ±(1.5% + 5) | 1V | ||
Frequency: 40Hz~400Hz; | ||||
Frequency of 400V and 600V: 40Hz~100Hz | ||||
DC Current | 40.00mA | ± (1% + 2) | 10uA | |
200.0mA | ± (1.5% + 2) | 100uA | ||
4.000A | ± (1.8% + 2) | 1mA | ||
10.00A | ± (3% + 2) | 10mA | ||
Overload protection: | ||||
self restoring fuse: 200mA/250V, 4A and 10A range no fuse. | ||||
AC Current | 40.00mA | ± (1.3% + 2) | 10uA | |
400.0mA | ± (1.8% + 2) | 100uA | ||
4.000A | ± (2% + 3) | 1mA | ||
10.00A | ± (3% + 5) | 10mA | ||
Frequency: 40Hz~400Hz; | ||||
self restoring fuse: 200mA/250V, 4A and 10A range no fuse. | ||||
Resistance | 400.0Ω | ±(1% + 3) | 0.1Ω | |
4.000KΩ | ±(1.2% + 5) | 1Ω | ||
60.00KΩ | 10Ω | |||
400.0KΩ | 100Ω | |||
4.000MΩ | 1KΩ | |||
40.00MΩ | ± (1.5%±3) | 10KΩ | ||
Overload protection: 220Vrms | ||||
Capacitance | 40.00nF | ±(3% + 5) | 10pF | |
400.0nF | 100pF | |||
4.000uF | 1nF | |||
40.00uF | 10nF | |||
100.0uF | 100nF | |||
Overload protection: 220Vrms | ||||
Diode | 0V~2.0V | |||
On-Off | <50Ω | |||
General Specification | ||||
Display | ||||
Display Type | 2.8 inch64K color TFT | |||
Display Resolution | 320 horizontal by 240 vertical pixels | |||
Display Contrast | Adjustable | |||
Power Supply | ||||
Supply Voltage | 100V-240VAC, 50Hz-60Hz; DC INPUT: 5VDC, 2A | |||
Power Consumption | <2.5W | |||
Fuse | T, 3A | |||
Battery | 2600mA*2 | |||
Environmental | ||||
Operating Temperature | 0~50 °C (32~122 °F) | |||
Storage Temperature | -40~+71 °C (-40~159.8 °F) | |||
Humidity | ≤+104℉(≤+40°C): ≤90% relative humidity | |||
106℉~122℉ (+41°C ~50°C): ≤60% relative humidity | ||||
Cooling Method | Convection | |||
Altitude | Operating and | 3,000m (10,000 feet) | ||
Nonoperating | ||||
Mechanical Shock | Random Vibration | 0.31gRMS from 50Hz to 500Hz, 10 minutes on each axis | ||
Nonoperating | 2.46gRMS from 5Hz to 500Hz, 10 minutes on each axis | |||
Operating | 50g, 11ms, half sine | |||
Mechanical | ||||
Dimension | 199 x 98x 40mm (L x W x H) | |||
Weight | 400g |
Hantek 2D82 Kfz-Diagnosekit II
Frequently Asked Questions
Have a Question?
Be the first to ask a question about this.