BLE 4 Click-Platine

The BLE 4 Click Board™ provides Bluetooth Low Energy connectivity for any embedded application. It features the NINA-B312, an integrated wireless connectivity solution. The NINA-B312 module itself is based on the nRF52840 chip, a flexible, efficient Bluetooth 5 and Bluetooth mesh multiprotocol SoC. Armed with such a powerful processor, the NINA-B312 can achieve data rates of up to 2 Mbps and up to 5 dBm maximum radiated output power using internal antenna, ensuring a reliable connection and good signal coverage. The BLE 4 Click Board™ is ideal for small smart devices like home automation sensor and fitness applications that need to require really low power consumption and long battery life.

How Does The BLE 4 Click Board™ Work?

The BLE 4 Click Board™ is equipped with the NINA-B312, Stand-alone Bluetooth 5 low energy module by u-blox, which is based on the nRF52840 chip. The nRF52840 is the mid-range member of the nRF52 Series SoC family. It meets the challenges of a broad range of applications that need Bluetooth 5 feature sets, protocol concurrency and a rich and varied set of peripherals and features. In addition, it offers generous memory availability for both Flash and RAM. It is operated by a set of AT commands, over the UART interface, which makes the BLE 4 click very easy to use.

By integrating most of the critical components on the chip, the NINA-B312 allows the module to overcome any imperfections of external discrete components, allowing signal transmission power of up to 10dBm, and -94 dBm sensitivity for the receiver, using the on-chip antenna.

The NINA-B312 module is built around an ARM® Cortex™-M4 CPU with floating point unit running at 64 MHz. It has NFC-A Tag for use in simplified pairing and payment solutions, as well as numerous digital peripherals and interfaces such as PDM. Therefore, BLE 4 Click has the onboard 2-pin header, that can be used for connecting the optional NFC antenna. It is also fully multiprotocol capable with full protocol concurrency. It has protocol support for Bluetooth 5, Bluetooth mesh, and 2.4 GHz proprietary stacks.

Besides the mikroBUS™ socket, the BLE 4 Click Board™ also features two onboard buttons T1 and T2. These buttons can be used for various purposes and user programmable. The BLE 4 Click Board™ also has an onboard user programmable RGB LED - LD2, which in combination with the mentioned buttons can be used for various purposes for basic user interaction without any external components required besides the BLE 4 click.

The BLE 4 Click Board™ is designed to be operated only with 3.3V logic level. A proper logic voltage level conversion should be performed before the BLE 4 Click Board™ is used with MCUs with logic levels of 5V.

SPECIFICATIONS

PINOUT DIAGRAM

This table shows how the pinout on the BLE 4 Click Board™ corresponds to the pinout on the mikroBUS™ socket (the latter shown in the two middle columns).

Notes	Pin					Pin	Notes
Data terminal ready	DTR	1	AN	PWM	16	DSR	Data set ready
Reset	RST	2	RST	INT	15	RTS	UART request to send
UART clear to send	CTS	3	CS	RX	14	TX	UART Transmit
NC	4	SCK	TX	13	RX	UART Receive
NC	5	MISO	SCL	12	NC
NC	6	MOSI	SDA	11	NC
Power Supply	3.3V	7	3.3V	5V	10	NC
Ground	GND	8	GND	GND	9	GND	Ground

ONBOARD SETTINGS AND INDICATORS