Product Description
Hardware
The Dediprog SF600 is designed with an ISP header, through an appropriate connector, users can connect the programmer and drive the SPI signals, supply the memory and control the controller or application status. Please refer to Table 1 for the SF600 2x10 header pin out. DediProg also provides the SF600 ISP Cable which is used to connect the SF600 programmer to the 2X6 2.54mm ISP Pin Header on board, please refer to Table 2 for the SF600 ISP Cable 2x6 pin out.
SF600 ISP Header Pin Out (2x10)
| 1 |
Vpp |
CS2 |
2 |
| 3 |
CS1 |
Vcc |
4 |
| 5 |
MISO/DQ1 |
Hold/DQ3 |
6 |
| 7 |
Wp/DQ2 |
CLK |
8 |
| 9 |
GND |
MOSI/DQ0 |
10 |
| 11 |
NC |
Reset/IO3 |
12 |
| 13 |
NC |
NC |
14 |
| 15 |
NC |
NC |
16 |
| 17 |
NC |
NC |
18 |
| 19 |
GPIO1 |
GPIO2 |
20 |
ISP Cable Connector Pin Out (2x6)
| 1 |
Vpp |
CS2 |
2 |
| 3 |
CS1 |
Vcc |
4 |
| 5 |
MISO/DQ1 |
Hold/DQ3 |
6 |
| 7 |
Wp/DQ2 |
CLK |
8 |
| 9 |
GND |
MOSI/DQ0 |
10 |
| 11 |
NC |
Reset |
12 |
SF600 Application Software
The SF600 USB software tool chain offers high flexibility and fits the different and highest requirements:
Engineering Mode
For engineers and expert to access advanced features for development, repairing etc.
Production Mode
The SF600 Application software supports Gang Programming. Additional programmers can be added at any time production capacity needs to be increased.
For operators in production to control multiple programmers and improve the throughput.
Command Line
Customer software can control multiple SF600 programmers by command line interface.
