Product Description
Hardware
The Dediprog SF600Plus is designed with an ISP header, through an appropriate connector, users can connect the programmer and drive the SPI signals, supply the memory and control the controller or application status. Please refer to Table 1 for the SF600Plus 2x10 header pin out. DediProg also provides the SF600Plus ISP Cable which is used to connect the programmer to the 2X6 2.54mm ISP Pin Header on board, please refer to Table 2 for the SF600PlusISP Cable 2x6 pin out.
SF600Plus ISP Header Pin Out (2x10)
| 1 |
Vpp |
CS2 |
2 |
| 3 |
CS1 |
Vcc |
4 |
| 5 |
MISO/DQ1 |
Hold/DQ3 |
6 |
| 7 |
Wp/DQ2 |
CLK |
8 |
| 9 |
GND |
MOSI/DQ0 |
10 |
| 11 |
NC |
Reset/IO3 |
12 |
| 13 |
NC |
NC |
14 |
| 15 |
NC |
NC |
16 |
| 17 |
NC |
NC |
18 |
| 19 |
GPIO1 |
GPIO2 |
20 |
ISP Cable Connector Pin Out (2x6)
| 1 |
Vpp |
CS2 |
2 |
| 3 |
CS1 |
Vcc |
4 |
| 5 |
MISO/DQ1 |
Hold/DQ3 |
6 |
| 7 |
Wp/DQ2 |
CLK |
8 |
| 9 |
GND |
MOSI/DQ0 |
10 |
| 11 |
NC |
Reset |
12 |
SF600Plus Application Software
The SF600Plus USB software tool chain offers high flexibility and fits different and the highest requirements:
Engineering Mode
For engineers and expert to access advanced features for development, repairing etc.
Production Mode
The SF600Plus Application software supports Gang Programming. Additional programmers can be added at any time production capacity needs to be increased.
For operators in production to control multiple programmers and improve the throughput.
Command Line
Customer software can control multiple SF600Plus programmers by command line interface.
