UVC Click Board™

MIKROE-4144
Regular price
£37.80
Sale price
£37.80
Regular price
£54.00
Sold out
Unit price
Quantity must be 1 or more

How Does The UVC Click Board™ Work?

The UVC Click Board™ can provide reliable and stable UVC light intensity value by using GUVC-T21GH sensor which have spectral detection range of 220nm - 280nm with output responsivity of 0.6mV/nW (at 254nm). Light intensity is converted in digital value by using MCP3221 a successive approximation A/D converter (ADC) with a 12-bit resolution.

Communication to the MCP3221 is performed using a 2-wire, I2C compatible interface. Standard (100 kHz) and Fast (400 kHz) I2C modes are available with the device. An on-chip conversion clock enables independent timing for the I2C and conversion clocks.

To get reliable readings from sensor, ADC power and voltage reference is supplied from MCP1501T-33E/RW a buffered voltage reference with 3.3V output capable of sourcing up to 20mA of current as a low-drift bandgap-based reference. The bandgap uses chopper-based amplifiers, effectively reducing the drift to zero.

Second way of reading output voltage from sensor is by placing 0 ohm resistor on JP2 position labeled on PCB and reading analog value from AN pin on mikroBUS™. This way you can relay on external voltage reference and ADC with some other desired specifications for your application and you can measure light power intensity up to 14.1 mW/cm².

An SMD jumper labeled as VCC SEL can be moved to the desired position, allowing both 3.3V and 5V MCUs to be used with the UVC Click Board™.

SPECIFICATIONS

Type Optical,UVC Light
Applications The UVC Click Board™ can be used for UV measurement applications, sterilization lamp monitoring, prototyping of wearables, handsets, and various consumer electronics based on received UV light
On-board modules GUVC-T21GH
Key Features UVC sensing with 12-bit resolution, High Sensitivity, Good Solar Blindness
Interface Analog,I2C
Compatibility mikroBUS
Click board size M (42.9 x 25.4 mm)
Input Voltage 3.3V or 5V

PINOUT DIAGRAM

This table shows how the pinout on the UVC Click Board™ corresponds to the pinout on the mikroBUS™ socket (the latter shown in the two middle columns).

Notes Pin Pin Notes
Analog Voltage Output AN 1 AN PWM 16 NC
NC 2 RST INT 15 NC
NC 3 CS RX 14 NC
NC 4 SCK TX 13 NC
NC 5 MISO SCL 12 SCL I2C Clock
NC 6 MOSI SDA 11 SDA I2C Data
Power Supply 3.3V 7 3.3V 5V 10 5V Power Supply
Ground GND 8 GND GND 9 GND Ground

ONBOARD SETTINGS AND INDICATORS

Label Name Default Description
PWR LD1 - Power LED Indicator
VCC SEL JP1 Left Logic level voltage selection: left position 3V3, right position 5V
JP2 Jumper NP Jumper for direct analog voltage reading from sensor

TECHNICAL SPECIFICATION

Characteristic Value
UVC sensing resolution 12-bit
Responsivity 0.6mV/nW
Spectral Detection Range 220nm - 280nm

Go to full site