Professional 2×6 ISP Cable for SF600 Programmer
The Dediprog SF600 ISP Cable (ISP-600-CB1-G) provides the essential connection between your SF600 programmer and target boards with 2×6 2.54mm ISP headers. This flat ribbon cable enables reliable in-system programming of SPI NOR flash memories directly on the PCB, eliminating the need to remove components for programming.
Wiring Quick-Start
Connect the cable between the SF600's 2×10 ISP header and your target board's 2×6 header. Ensure pin 1 alignment using the red stripe indicator on the ribbon cable. The cable converts the SF600's full 2×10 pin arrangement to the standard 2×6 configuration used by most target boards.
| Pin | Signal | Signal | Pin |
|---|---|---|---|
| 1 | Vpp | CS2 | 2 |
| 3 | CS1 | Vcc | 4 |
| 5 | MISO/DQ1 | Hold/DQ3 | 6 |
| 7 | Wp/DQ2 | CLK | 8 |
| 9 | GND | MOSI/DQ0 | 10 |
| 11 | NC | Reset | 12 |
Signal Descriptions
- CS1/CS2: Chip Select lines for addressing multiple SPI devices
- MOSI/DQ0: Master Out Slave In data line (or Data I/O 0 in quad mode)
- MISO/DQ1: Master In Slave Out data line (or Data I/O 1 in quad mode)
- CLK: Serial clock signal for synchronising data transfers
- Vcc: Target voltage supply (1.8V to 5V)
- Hold/DQ3: Hold signal for pausing operations (or Data I/O 3 in quad mode)
- Wp/DQ2: Write Protect signal (or Data I/O 2 in quad mode)
Compatible Applications
This cable is specifically designed for use with SF600, SF600Plus, and SF600Plus-G2 programmers when programming SPI flash devices on target boards that feature the standard 2×6 ISP header layout.