Spirit Click Board™

MIKROE-2568
Regular price
£32.90
Sale price
£32.90
Regular price
£47.00
Sold out
Unit price
Quantity must be 1 or more

The SPIRIT Click Board™ carries the SP1ML 868MHz ultra low-power RF module. The board is designed to use 3.3V power supply and 3.3V or 5V I/O voltage levels. It communicates with the target MCU over UART interface, with additional functionality provided by the following pins on the mikroBUS™ line: PWM, RST, CS.

It can be used to wirelessly send and receive UART data.

SP1ML 868MHZ RF MODULE FEATURES

SP1ML is based on the SPIRIT1 RF sub-GHz transceiver (with integrated SMPS), STM32L1 microcontroller, integrated filter/balun, and chip antenna.

There are two operational modes, command mode and operating mode. The command mode allows module configuration and status interrogation using an extended 'AT' style command set. In operating mode the module serves its primary purpose as a wireless transceiver.

In operating mode the module uses only 13.5mA, 2.2mA in command mode, and even lower in standby with just 1.4µA. This kind of power consumption makes it ideal for smart devices that send small amounts of data.

The module has an integrated antenna and crystal.

SPECIFICATIONS

Type Sub-1 GHz Transceivers
Applications Security systems, mobile health and medicine applications, IoT, wireless metering, etc.
On-board modules SP1ML 868MHz ultra low-power RF module
Radio Region Europe
Key Features Low data rate, low power sub-GHz transceiver
Interface GPIO,UART
Compatibility mikroBUS
Click board size M (42.9 x 25.4 mm)
Input Voltage 3.3V or 5V

PINOUT DIAGRAM

This table shows how the pinout of SPIRIT Click Board™ corresponds to the pinout on the mikroBUS™ socket (the latter shown in the two middle columns).

Notes Pin Pin Notes
NC 1 AN PWM 16 SHDN Shutdown
Reset input, active low RST 2 RST INT 15 NC
Command mode CMD 3 CS TX 14 TXD UART transmit data
NC 4 SCK RX 13 RXD UART receive data
NC 5 MISO SCL 12 NC
NC 6 MOSI SDA 11 NC
Power supply +3.3V 7 3.3V 5V 10 +5V Power supply
Ground GND 8 GND GND 9 GND Ground

JUMPERS AND SETTINGS

LOGIC SEL - used to select 3.3 or 5V logical level for UART communication (J1A in the schematic).

Go to full site