RN4678 Click Board™

MIKROE-2545
Regular price
£32.20
Sale price
£32.20
Regular price
£46.00
Sold out
Unit price
Quantity must be 1 or more

RN4678 MODULE FEATURES

The RN4678 from Microchip is a fully certified, Bluetooth version 4.2 module. Use it to add Bluetooth wireless capability to your project.

The module includes an on-board Bluetooth stack, power management subsystem, 2.4 GHz transceiver, and RF power amplifier.

Data transfer is achieved through the Bluetooth link by sending or receiving data through SPP in Bluetooth (BT) Classic mode and through Transparent UART in the BLE mode.

The RN4678 contains an integral ceramic chip antenna.

STRONG ENCRYPTION

The RN4678 module has strong AES128 Encryption. A 128-bit encryption is one of the most powerfull encryption algorithms. AES stands for Advanced Encryption Standard and it is a symmetric encryption algorithm.

SPECIFICATIONS

Type BT/BLE
Applications Internet of Things (IoT), secure payment, home and security, health and fitness, industrial and data logger, LED lighting, etc.
On-board modules RN4678 module from Microchip
Key Features Frequency: 2.402 GHz to 2.480 GHz, RX Sensitivity: -90 dBm (BR/EDR), -92 dBm (LE), Bluetooth SIG 4.2 Qualified
Interface I2C,GPIO,UART
Compatibility mikroBUS
Click Board™ size M (42.9 x 25.4 mm)
Input Voltage 3.3V

PINOUT DIAGRAM

This table shows how the pinout on RN4678 Click Board™ corresponds to the pinout on the mikroBUS socket (the latter shown in the two middle columns).

Notes Pin Pin Notes
Software Button SW_BTN 1 AN PWM 16 WKUP Wake-up from Sleep mode
Module Reset (internal pull-up). Apply a pulse of at least 63 ns. RST_N 2 RST INT 15 CTS Clear To Send
Configurable Control or Indication pin or UART RTS (output) RTS 3 CS TX 14 TXD UART data output
NC 4 SCK RX 13 RXD UART data input
NC 5 MISO SCL 12 SCL I2C Clock
NC 6 MOSI SDA 11 SDA I2C Data
Power supply +3.3V 7 3.3V 5V 10 NC
Ground GND 8 GND GND 9 GND Ground


JUMPERS AND SETTINGS

Designator Name Default Position Default Option Description
JP1 P2_0 Left HIGH System configuration pin - Along with P2_4 and EAN pins, used to set the module in any of the following three modes: Application mode (for normal operation), Test mode (to change EEPROM values), and Write Flash mode (to enter the new firmware into the module);
JP2 P2_4 Left HIGH System configuration pin - Along with P2_0 and EAN pins, used to set the module in any of the following three modes: Application mode (for normal operation), Test mode (to change EEPROM values), and Write Flash mode (to enter new firmware into the module);
JP3 EAN Right LOW External address-bus negative pin. System configuration pin along with P2_0 and P2_4 pins, used to set the module in any of the following three modes: Application mode (for normal operation), Test mode (to change EEPROM values), and Write Flash mode (to enter new firmware into the module);

Go to full site