PWM Driver Click Board™

MIKROE-2272
Regular price
£16.10
Sale price
£16.10
Regular price
£23.00
Sold out
Unit price
Quantity must be 1 or more

If you need to control DC motors with loads up to 10A, the PWM Driver Click Board™ is the perfect solution, thanks to the Silicon Lab Si8711CC one-channel isolator. It communicates with the target MCU over PWM pin, and runs on a 5V power supply. It can be used in a wide variety of ways, from controlling light intensity to serving as an ON/OFF switch to control DC load circuits.

MOSFET TRANSISTOR

The PWM Driver Click Board™ contains a P-channel DMP3010LK3 MOSFET transistor. When the PWM Driver Click Board™ is used for PWM control it is not recommended to use it with loads of wattage over 50W because the MOSFET chip can get overheated; however, this does not apply when the click is used as an ON/OFF switch.

ONBOARD SCREW TERMINALS

There are two pairs of screw terminals on the PWM Driver Click Board™ — one for the external power supply and one for the DC load.

APPLICATION

DC motor speed control, electronic ON/OFF switch for controlling DC load circuits, light intensity control, etc.

SPECIFICATIONS

Type Brushed
Applications The PWM Driver Click Board™ is suitable for DC motor speed control, as an electronic ON/OFF switch for controlling DC load circuits, light intensity control, etc.
On-board modules Silicon Lab Si8711CC one-channel isolator, P-channel DMP3010LK3 MOSFET transistor
Key Features Two pairs of screw terminals
Interface PWM
Compatibility mikroBUS
Click board size M (42.9 x 25.4 mm)
Input Voltage 5V
Go to full site